iCarSoft i910-II

Discussion in 'BMW Diagnostic, programming and software discussion' started by manosm3, Jul 31, 2018.

  1. 31 Jul 2018 at 2:03 PM #1
    manosm3

    manosm3 A mere Chipper

    Joined:
    Jul 11, 2018
    Messages:
    43
    Likes Received:
    0
    Trophy Points:
    0
    Your Motor:
    2005 BMW M3 CS
    Colour Combo:
    Opal Black / Cinnamon (extended)
    Although my OBD works fine -has power and laptop diagnostics can be performed- I can't run a diagnosis with the iCarSoft i910-II. It receives power from OBD, seems to start scanning and at the end it shows "communication error".
    Tool was tested on BMW 6 series and was performing fine. Also firmware is v3.0.

    Any ideas?
     

Users Who Are Viewing This Thread (Users: 0, Guests: 1)

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice